真空滾揉機保養：

Maintenance of vacuum rolling machine：

真空滾操機的消費進程復雜,由于處在一個真空的環境,因而消費出來的食物都十分潔凈衛生,可以契合人們運用的規范，而且整個腌制進程十分迷信嚴謹，因而肉的滋味也可以拿捏的很棒，因而才會有更多的人選擇運用真空滾揉機了。

The consumption process of vacuum rolling machine is complex. Because it is in a vacuum environment, the food consumed is very clean and hygienic, which can meet the standard of people's use. Moreover, the whole curing process is very superstitious and rigorous, so the taste of meat can be very good. Therefore, more people choose to use vacuum rolling machine.

1、每次任務完畢翻開真空油水別離器底閥開關,放盡積水。肅清真空吸入物質。清洗真空油水別離器保證真空管路疏通。

1. At the end of each task, turn on the bottom valve switch of the vacuum oil-water separator and drain the water. Clean up vacuum inhalation. Clean the vacuum oil-water separator to ensure that the vacuum pipeline is unblocked.

2.真空泵應該每月-次停泵反省油的凈化狀況,假如真空泵內油的狀況曾經被凈化,則應該及時換油。換油之前泵需空載正轉15分鐘。讓油加熱后停泵旋開放油塞將污油放盡。用一些新油或許清洗用油清洗泵后注入新的真空泵油。( 新油為10#汽油或許機油)真空泵的維護和頤養可參照真空泵運用闡明書執行。

2. The vacuum pump should be shut down once a month to check the purification condition of oil saving. If the oil condition in the vacuum pump has been purified, the oil should be changed in time. The oil pump needs to be changed 15 minutes before no-load operation. After the oil is heated, stop the pump and open the oil plug to drain the dirty oil. After cleaning the pump with some new oil or cleaning oil, inject new vacuum pump oil. (new oil is 10 × gasoline or engine oil) the maintenance and maintenance of vacuum pump can refer to the operation instructions of vacuum pump.

3.常常反省蝸輪加速機油位。假如發現油位低于油窗高度1/2時應該及時參加30#機器油。

3. Often reflect on the oil level of worm gear accelerator. If it is found that the oil level is lower than 1 / 2 of the oil window height, it is necessary to timely participate in the 30 ° machine oil test.